I have purchased and installed a new Bend-Pak 2 Post Lift. Question is Where to locate lift pads on 1994 Corvette, info. with lift was not specific enough, pictures would be a great help. Are there special lift brackets I should get to attach to lift?
Submitted by: Craig Spoon
|
We place a large rubber pad (about 8"x 8") on the hoist arm directly beneath the Jacking area, marked along the lower body panel of the C4 corvettes. Cut the rubber pads out of old tires.
Important not to lift on body, it will crack or break. Lift only on frame.
The hoist arms are too long to lift at correct point, so we just lay rubber pan on arm at lifting point. Send email address and I can send you pictures. jimjondahl@cableone.net
|
Master Certified Vehicle Inspector on
10/13/2007 8:02:38 PM
|
